The main component of granite is quartz and feldspar, texture is relatively hard. Cone crusher with high efficiency, good effect usually been used in crushing it. We consulted manufacturers of cone crusher to get the info of the cone crusher equipment’s price and parameter. So this article mainly introduces the price and parameter of cone crusher.
The granite belongs to high hard rock, we usually use cone crusher to crush and grind it, because cone crusher has big crushing ratio and high crushing efficiency.
Cone Crusher is widely used in crushing ores and rocks in the construction, building materials, hydropower, and transportation industry and so on. As a professional Cone Crusher Manufacturers, The THPC400 cone crusher produced by SBM has reached the world's highest crushing technology level, in structure design, the shape of speed of middle shaft, impact, and crushing chamber been optimizes combination to achieve the ore material inter-grain laminated crushing, it not only increases production, but also achieves the effect of selective crushing on the material, in a great extent, it reduces the useless material, such as: flakiness of these materials and so on, which also effectively reduces the unnecessary waste of resources.
If the capacity of crusher is been required to achieve more than 400 tons per hour, including 400 tons per hour, it is recommended to use HPC400 Coarse Cavity Cone Crusher Equipment. The maximum feed size of this cavity-type cone crusher can reach 290mm; minimum discharge opening size can be adjusted to 30mm.The Capacity of HPC400 cone crusher can be up to 400 tons per hour or more in the ideal state. In this case, the SBM configures motor 400kw for hers HPC400 cone crusher.
When we use HPC400 Cone crusher to crush the granite, should pay attention to the following matters:
1, Before using the HPC cone crusher, we should check the lubrication system, the crushing working area of cone, and also correct the degree of the belt tension, tighten all the needles.
2, We should open the pump motor for 5-10 minutes, to check the working condition of the cone crusher’s lubrication system, when it normally works, we can open the main motor.
3, after the HPC cone crusher no-load running 1-2 minutes, we can begin to feed the ore.
4, When we want to stop working, should firstly stop feeding ores, check if all the ores in the crusher be discharged, then we can stop running the main motor, final stop the pump motor. We need to check all the parts of the crusher after stopping working, if found out any problem, should solve it timely.
Granite cone crusher is mainly to process 320Mpa and more than 320Mpa hardness ores and rocks, while in the structure of manufacturing, which is reasonably reliable, high efficiency, and effectively overcomes the strong hardness characteristics of tailings and slag, on the basis, to achieve the tailings process and reusing, so cone crusher not only makes a great contribution for the protection of air quality, but also achieves the maximum benefits. Meanwhile, the Price of this Cone Crusher is cost-effective and reasonable; it is your first choice for granite processing equipment.
Jaw crusher is mainly used for crushing various ores and large materials with compression strength not more than 320Mpa.
High frequency screens feature aggressive vibration applied directly to the screen that allows for the highest capacity in the market.
SCM ultrafine mill has been exported to more than 130 countries used in super grinding industry.
T130X reinforced ultrafine mill is a new facility designed by SBM expert basing on statistical analysis and a large number of suggestions from users.
VSI crusher is the original rock-on-rock crushing equipment used in the third of fourth stage of crushing circuits.