The stone crusher can be used for crushing work in all walks of life, and it is superior in function range to other crushing equipment. However, when the stone crusher breaks some soft materials like clothing, wood, plastic film and many electronic integrated boards, etc., the stone crusher belt runs because the stone crusher belt type is wrong or the equipment is aging or other problems. There will be slippage problems in the process, so how to deal with the slippage problem of the stone crusher belt?
When the stone crusher conveyor belt slips, check if the load on the stone crusher belt is exceeded. If the load of the stone crusher belt is too large and exceeds the compliance of the motor, slippage will occur. Although the slip at this time is a protective measure for the motor, it is necessary to adjust the feeding amount in time to control the stone crusher conveyor belt within a very large load to avoid the occurrence of material slip.
The stone crusher belt starts too fast and is also prone to slippage. In response to this situation, the speed of the equipment startup can be re-adjusted according to the different crusher belt models and the hardness of the processed materials, and the speed can be quickly adjusted to medium or slow speed, which can effectively slip the customer. In addition, it is necessary to eliminate the slippage caused by insufficient friction between the drive roller and the conveyor belt of the stone crusher. This requires that the belt of the stone crusher should not be wet or who can use the blower to blow the rosin on the drum.
Different crusher belt models have different tensions, so the selection of the stone crusher belt must be in accordance with the model selection of the equipment. In addition, it is necessary to check the tension of the conveyor belt of the stone crusher. If the tension of the conveyor belt leaving the drum is not enough, it is prone to slippage. In order to solve this problem, the customer should timely correct the tensioning device on the belt of the stone crusher. Increase the initial tension of the belt. If the tail roller bearing is damaged or the upper and lower roller bearings are damaged seriously, the belt slippage will also occur if there is no timely repair or replacement of the inflexible parts.
For the slippage problem of materials and belt conveyors, the new "human" shaped gravel belt can effectively increase the friction, and the problem of material and belt slip can be solved perfectly. The engineer also optimized the stone crusher belt conveyor structure and standardized production for easy operation and maintenance. However, it is important to remember that the choice of the type of crusher belt must match the model of the equipment.